Quadcopter

This quadcopter is based on MikeyB’s original designs with some modifications. I changed some things that I found were problematic to my hardware configuration.

The mount for the kk2 controller was rotated 45 degrees in order to get it to allign forward with an X configuration quadcopter.

Also it features a top mount for an fpv camera, while removing the go-pro mount at the bottom.

Some other minor modifications include new strap holes for battery, and also grooves to keep components from sliding.

The quadcopter was printed on an UltiMax DYI 3D printer.
I also used their filament which printed very well.
http://www.ultibots.com/ultimax-3d-printer-diy-kit/

 

 

source @ thingiverse


Leave a Reply

Your email address will not be published. Required fields are marked *